The Honda PCX / Forza / ADV150 / SH Forums

Forgot to say, buy everything on your credit card and dont bother with cash if you can. Make sure you pay off the full ammount each month to avoid interest.

Pay off the loan rather than having savings unless the loan is 0%. If you really want to improve your credit rating then just get a credit card and pay off the full amount each month, that way it wont cost you anything.

The top set is an extra brake light as the large givi box reduced the visibility of the original lamp, it only comes on when the brake is applied.

£4 from eBay, ha! Should have used 1x 80cm to look cleaner but its still okay.

Next i plan to install some 5050 smd to the front as shown, should give good front and side vis. The 5050 strips are 10mm which give out more light (over the rear 8mm i used) so should help but could be tricky to fit...

Wired to the brake bulb, interesting effect that i didnt expect is that they turn off when i pull the bake but as i have an extra brake bar it works quite well.. If i was to do it again i would use one 90cm strip rather than 2x 30cm as it would look much neater and give out more light but would need...

In low light

Finally got round to fiiting the 3528 SMD strips i got...and they are actually better than i thought!

pcx has the best wheels of any scoot so it would be nice to see some customised ones. Maybe white on a black pcx like the old vfr 400...

Seat switch must have failed, surprising as i had to glue mine down as it deactivated too easily!

Well i know what bulb to get... http://www.ebay.co.uk/itm/Honda-PCX-125-WW125EX2-2010-Stop-Tail-Light-Replacement-Bulb-/370759647928#vi-content but not finding it in led with offset pins, think its not worth the bother so ill just stick the run lights on and im sure the battery will be fine. Ive use...

Agreed, that bulb looks terrible! I'm sure it's an offset push in bulb...

Hate to say i glued my switch down in the first week of owning it, wouldnt think to tell the next owner i had done it either!

Did mine myself and the result works but is weeeeell below this standard, worth it for the leg room tho. Going to Thailand in sept so im tempted to look for this shop and fill my hand luggage up with goodies! Think if you have a new bike its worth the cash but mines 2 years old so its not really mon...

Only reason in want to swap it is a have a 30cm led strip to go on the grab rail for visibility. Figured replacing incandescent with led should offset the power usage of the led strip? I know nothing about electrics tho!

Can anyone point me in the direction of a decent replacement led tail bulb, one that flashes for a second would be good. Ive seen a couple on ebay but ive heard some are real good and others awful...

Well i had good intentions of legally buying a service manual buuuutttt...

Thank you all for the help! I have finally got a replacement front tyre (citygrip to match rear), had the rear removed/checked/refitted and all now appears well! Bearings are i little worn but ok apparently...may get replacements ordered if i can find some. Talking to the shop guy theres a possibili...

Mine flashes at 130 miles and runs out at just over 150 miles...as i found out the hard way!

Ive got one shock off and it seems fine so far, where it attaches to the swing arm there is a rubber bushing or maybe a bearing thats solid? The shock flaps around a lot at the top now i took the bottom off but i would imagine thats normal. Wish i knew more about scooters but im actually quite enjoy...