Empty hole next to ignition keyhole

SmellyTofu · Post by **SmellyTofu** » Sat Jan 05, 2013 4:32 am

Can anyone tell me what the purpose of this hole is for? Hazard light switch?

Alibally · Post by **Alibally** » Sat Jan 05, 2013 4:40 am

It's the hole for checking the combi brake fluid level.

Taz · Post by **Taz** » Sat Jan 05, 2013 4:55 am

All covered in detail here:

http://www.hondapcx.org/viewtopic.php?f=2&t=683

SmellyTofu · Post by **SmellyTofu** » Sat Jan 05, 2013 12:37 pm

Thanks! I thought I had to remove a panel for that.

C-Note · Post by **C-Note** » Mon Jan 07, 2013 11:20 am

That opening on my scoot is empty as well. There's nothing there?

What's that all about? I am wondering if that indicator popped out last fall when I replaced panels, and I didn't notice it at the time.

Hmmm.... can anyone confirm?

Taz · Post by **Taz** » Tue Jan 08, 2013 12:49 am

Mine is blank too. Can anyone take a close up pic of the measuring device and I can ask the dealer here about it. I wonder if some countries get it and others dont?

Alibally · Post by **Alibally** » Tue Jan 08, 2013 2:07 am

There is no measuring device. It's just a hole for looking through at the fluid level.

Alibally · Post by **Alibally** » Tue Jan 08, 2013 2:11 am

: ImageUploadedByTapatalk1357629060.750094.jpg (52.95 KiB) Viewed 2805 times

C-Note · Post by **C-Note** » Tue Jan 08, 2013 10:56 am

I looked in my service manual last night and found the same page as is posted here. Looks to me like there should be a reservoiur behind the opening. From the photo in the other thread http://www.hondapcx.org/viewtopic.php?f=2&t=683 it looks like the reservoir tank has a protrusion (or something) that actually seats in that opening.

I haven't seen my scoot in a while as it's covered up for the winter, but I'd swear there was nothing in that opening on my bike. I remember looking right at it and wondering why there was nothing there. I guess I'm going to have to take a look now, I'm curious. If there's nothing there I'll take off the cover and see if it got jarred out of place from the spill I took last fall.

I'll let you all know what I find out. It'll probably be few days before I can get out there to look.

Taz · Post by **Taz** » Tue Jan 08, 2013 8:35 pm

ok so you need to shine a torch into the hole to see the fluid level. Looks blank under normal light.

WhiteNoise · Post by **WhiteNoise** » Tue Jan 08, 2013 10:40 pm

I took this today. Fluid is at half mark between lower/upper. Hope you gets things sorted asap. I'd be a bit miffed myself!

C-Note · Post by **C-Note** » Wed Jan 09, 2013 12:15 pm

WhiteNoise wrote:I took this today. Fluid is at half mark between lower/upper. Hope you gets things sorted asap. I'd be a bit miffed myself!

WhiteNoise.... Looking at your latest pic, mine does NOT look like that. The hole goes straight thru, there's nothing behind it except the back of a panel.

Gonna have to pull the little ignition panel off and see what's up.

you you · Post by **you you** » Wed Jan 09, 2013 1:39 pm

Mine looks slightly different. Reserviour is set further back and the panel doesn't have the trim finishing grommet

maddiedog · Post by **maddiedog** » Wed Jan 09, 2013 1:43 pm

Sounds like your dealer owes you a grommet then, qed.

Mine has the grommet too.

you you · Post by **you you** » Wed Jan 09, 2013 1:47 pm

It looks like the access hole and the reservoir are smaller tbh

Anyhoo the bike will be faster without the grommet, less weight..

maddiedog · Post by **maddiedog** » Wed Jan 09, 2013 2:20 pm

qed wrote:It looks like the access hole and the reservoir are smaller tbh

Anyhoo the bike will be faster without the grommet, less weight..

Same reason I shave my legs and ride naked, adds +0.01mph.

you you · Post by **you you** » Wed Jan 09, 2013 6:39 pm

maddiedog wrote:
qed wrote:It looks like the access hole and the reservoir are smaller tbh

Anyhoo the bike will be faster without the grommet, less weight..
Same reason I shave my legs and ride naked, adds +0.01mph.

Your making light of things but a good poo before setting off always helps the power to weight ratio....

C-Note · Post by **C-Note** » Thu Jan 10, 2013 11:20 am

Well, I went out and took a closer look at my bike. I stuck my finger in the opening and I'll be damned, the reservoir is there. It's just back a bit and hard to see.

WhiteNoise · Post by **WhiteNoise** » Thu Jan 10, 2013 11:39 am

Good to hear!

Can you see the fluid level? Due to the "set back" it must be hard to read

brendan_honda · Post by **brendan_honda** » Thu Jan 10, 2013 5:07 pm

qed wrote:Mine looks slightly different. Reserviour is set further back and the panel doesn't have the trim finishing grommet

Mine doesn't have the grommet either. is yours an esp model?

The Honda PCX / Forza / ADV150 / SH Forums