Page 1 of 1
New slow pcx?
Posted: Tue Mar 02, 2021 11:21 am
by Shlouski
Hi guys, I bought a new 2021 pcx 125 last week and I'm not sure it's running right. I've had a couple of 50cc and 125cc bikes a while back, and I'm sure they were faster. Today I was overtaken by 2 50cc bikes, even flat out I could not keep up with them. The bike tops out around 50kph up hill and around 80kph down hill, is this normal?
Re: New slow pcx?
Posted: Tue Mar 02, 2021 11:34 am
by Conelite
31mph max for a bike that should go well over 50mph? Something is definitely wrong. Return to the dealer and have them inspect it.
Re: New slow pcx?
Posted: Thu Mar 04, 2021 10:52 pm
by op3l
Maybe check your brakes to make sure they're not staying clamped on?
Even a 125 should do well over 80 kph...
Re: New slow pcx?
Posted: Mon Mar 08, 2021 12:17 am
by MicBergsma
Check the rollers / sliders...
Re: New slow pcx?
Posted: Fri Mar 19, 2021 4:38 pm
by lion_typer
Id possibly ride 1,000 miles to let the engine break in.
Re: New slow pcx?
Posted: Sat Mar 20, 2021 9:12 am
by Yorkie150
buy a brand new bike......then try and see what its top speed is ???? receipe for disaster waiting to happen...Let it bed in / run in....slowly and carefully....done properly it will run for thousands of miles...done incorrectly ....a new engine / new bike very quickly
Re: New slow pcx?
Posted: Tue May 04, 2021 5:01 pm
by Red Thunder
I say check the brakes also. Put it up the center stand and turn the rear wheel by hand then squeeze the rear brake then see if the rear wheel is hard to move or spins freely.
I had this happen to me as well , If hat is the case you may need to remove the rear wheel and make sure the brake pads are seated correctly. Mine was off somehow on the part that moves to spread the brake pads apart and it was stick and the brakes would stay locked up after I used the rear brake.
A pain to get to butt fixed the problem,
I did notice also when I changed out rollers on my variator that they were tight so I used an INDIA stone or knife sharpening stone on the side to smooth out any high spots an inconsistencies in the roller. It worked out just fine. The stone is MUCH more forgiving than if you were to use a file or sand paper
Re: New slow pcx?
Posted: Wed May 05, 2021 9:25 am
by SantinoInc
So whatever happened with your bike? You started the thread and never told us what the issue ended up being
Re: New slow pcx?
Posted: Mon Feb 14, 2022 4:03 pm
by Charliemcmaster87
Hi did you manage to resolve the issue i have recently picked up a new 2021 honda pcx 125 and it seems slow?