2012 PCX150 Valve Adjustment

[Ralf_CT]

Can someone please advise on the locking nut and square adjuster size on the 2012 PCX150 inlet and exhaust valves. I want to order a tool from Amazon, some list a 9mm nut/3mm square and others 10mm/3.5mm.

Many thanks.

[Ralf_CT]

Has nobody here set the valves on a 2012 PCX150 before?

[Ganglylamb]

Oh something like this? It took me only ~24hrs to fetch my valve adjustment tool out of my toolbox, take this picture, upload it and place it in this response.

valve adjust tool.jpg (119.37 KiB) Viewed 1721 times

Now let me go and look for my caliper Patience is a virtue - wait am I on 'insta' board ?!?

The official tool as per the service manual can be found at https://www.partzilla.com/product/honda/07908-KE90200

Wait for it...


one more teaser:

guess the size.png (14.18 KiB) Viewed 1720 times

[Ralf_CT]

Thank you for the info. I was considering one of these two from Amazon:

1. https://www.amazon.com/dp/B083QGP7YD/?c ... _lig_dp_it
2. https://www.amazon.com/dp/B09VY3RP7T/?c ... _lig_dp_it

It's quite possible both are wrong, hence the need to know the adjuster and square size.

[Ganglylamb]

I really cant find my caliper so anyhow;

The square part is 3 mm.

valve adjustment wrench.png (16.28 KiB) Viewed 1697 times

[iceman]

Most people don't bother adjusting valves and the bikes run fine for years - mines 9 years old, still starts 1st time and rides perfectly giving 130mpg+ even in these colder conditions. Many say if the bike starts, rides and sounds fine - no need ripping it apart.

[Jge64]

Yup…… I have about 8k miles on my Xmax and I’ve never adjusted the valves. Recently I had it in for a bad starter. I asked my Tech if we should adjust the valves, he said “ I’d be glad to take your money, but you really don’t need to do it, if it’s starting and running fine, leave it alone”… He’s a master tech of 20 years with Yamaha, and I appreciated his honesty.