Honda NSC/Vision 110 Variator nut torque?
Posted: Fri Oct 16, 2020 11:23 am
Hello everyone
I tried posting my question in the "Other Bikes" section but got no replies so I'm posting this here since there's more people viewing this section, apologies for posting about a non PCX bike.
I'm trying to replace the drive belt on my 2013 Honda NSC/vision 110 and I can't find a workshop manual or any info online for how much I should torque up the variator nut, does anyone have any info/advice as to what torque I should use?
The only information I could get was from a Dutch forum which recommended 59 Nm for the 50cc Vision and I know that the PCS 125'S Variator nut is torqued to 59 Nm also. Any help or advice would be very appreciated as I need to change the belt asap but don't know how much to tighten the nut.
Regards
I tried posting my question in the "Other Bikes" section but got no replies so I'm posting this here since there's more people viewing this section, apologies for posting about a non PCX bike.
I'm trying to replace the drive belt on my 2013 Honda NSC/vision 110 and I can't find a workshop manual or any info online for how much I should torque up the variator nut, does anyone have any info/advice as to what torque I should use?
The only information I could get was from a Dutch forum which recommended 59 Nm for the 50cc Vision and I know that the PCS 125'S Variator nut is torqued to 59 Nm also. Any help or advice would be very appreciated as I need to change the belt asap but don't know how much to tighten the nut.
Regards