The Honda PCX / Forza / ADV150 / SH Forums

Today I noticed a piece of rubber sticking out from under the body panel just above the rear tire. It looks like a shield to keep dirt from getting on the engine. The one on the left side is hanging, and the one on the right side is gone. Time for a trip to the dealer. Just a heads-up for other Forza owners.

Left side:

2042 by ScubaDude1960, on Flickr

Right side:

2044 by ScubaDude1960, on Flickr

And a photo I took the day I got the bike:

1961-c by ScubaDude1960, on Flickr

I found one of them undone when I got mine but I just connected it back on.

At least the PCX doesn't fall apart within minutes

I check the bike every day and so far have not noticed this problem.

Jim

you you wrote:At least the PCX doesn't fall apart within minutes

No, it takes hours rather than minutes for the crankcases to self-destruct.

gn2 wrote:I found one of them undone when I got mine but I just connected it back on.

I can't figure out where to connect the other end. The only hole I can find is in a tab on the metal frame up under the plastic bodywork, but it's too big.

gn2 wrote:

you you wrote:At least the PCX doesn't fall apart within minutes

No, it takes hours rather than minutes for the crankcases to self-destruct.

Both of you make me thanks, I needed that

actually my 2013 PCX 150 did have loose parts....some of the plastic was loose and I only discovered so because i did all my own servicing. some of the 6mm's and the body panel screws....but you know built in japan but assembled here so sloppiness abounds....

Thought the PCX was manufactured and assembled in Thailand?

gn2 wrote:Thought the PCX was manufactured and assembled in Thailand?

Dealer told me that mine was made in Italy?

You'll be able to tell from your VIN