The Honda PCX / Forza / ADV150 / SH Forums

Never checked my rear brake in the 3 years and 16000 miles ive had it...shoes were very low and was full of dust!

http://www.youtube.com/watch?v=P4C08EreZE0

A nice job and thanks for the video.

It's definitely going to be easier if you put your scooter on its side stand (like you did) when trying to release the big axle nut of the rear wheel.

You could use a velcro strap to lock in the rear brake handle before you start on the job. Or get somebody to help and sit on your bike.



The axle nut can be a hard nut to crack. I did it this way on my Vespa LX 150. I don't have an impact driver. I just placed my leg and some of my body weight on the handle of the socket wrench to loosen the nut that refused to co-operate.

Good advice!

I bought the impact driver for the variator nut but it worked well for the wheel too. Its worth the £30 but you wouldn't want to carry it with you so its good to see alternatives especially if your touring, a bit of velco isnt much to carry.

What are those things on your handlebars in the video? Is that something for winter?

I just put it on the side stand, put a cable tie on the brake lever to apply the combi brake and used a 1/2" drive breaker bar to undo the nut.

Mgalutia88 wrote:What are those things on your handlebars in the video? Is that something for winter?

Handle bar muffs! Keeps the rain and wind off, but they do look a little silly. I ride all year round in the snow, rain and frost so they are essential really.

What brand are hey and where can we get some??? Are they generic fit or bike specific?

Its the R319 that fit the PCX, expensive but the best. You can get cheapo ones on ebay for like £15, most can be forced to fit but my first pair only lasted a year so i bought the Tucano.

http://www.urbanrider.co.uk/brands/tuca ... ights.html

Been wondering how to remove the rear wheel and found this topic and link to the fantastic video - thanks Ben!

What size is the rear axle nut? (Sorry if the answer is in the video, I couldn't catch it.)

Really useful and interesting video. Thanks a lot!!!

pcxpower wrote:Really useful and interesting video. Thanks a lot!!!

Agree. Some good links from it too

No one knows the size of the rear axle nut?

Branyers wrote:No one knows the size of the rear axle nut?

If you are planning on removing it why don't you check it's size using one of your sockets?

I have to buy one. The biggest I have is a 22mm, and that is still too small.

Branyers wrote:I have to buy one. The biggest I have is a 22mm, and that is still too small.

Understand. I'll check tomorrow

Just found a cheap pair of calipers lying around. I got 24mm. Is that what you get?

Branyers wrote:Just found a cheap pair of calipers lying around. I got 24mm. Is that what you get?

Sorry about the delay - yes 24mm

Great video and informative !.
Six point 24 mm socket would probably be best for that torque spec.