Here's the Ol' Gal
Posted: Sat Jan 18, 2014 9:01 am
- pcx1.JPG (738.26 KiB) Viewed 1320 times
) after it's weekly wash, why does it get so dirty! ) after it's weekly wash, why does it get so dirty!The Honda PCX / Forza / ADV150 / SH Forums
Your predominant source of information for the Honda PCX, Forza and SH! Now featuring an ADV150 subforum!
https://hondapcx.org/
Here's the Ol' Gal
Page 1 of 1
First picture of the Ol' Gal ( Norfolk term of endearment ) after it's weekly wash, why does it get so dirty!
) after it's weekly wash, why does it get so dirty!Re: Here's the Ol' Gal
Posted: Sat Jan 18, 2014 11:23 am
Use! As it should be!
Re: Here's the Ol' Gal
Posted: Sat Jan 18, 2014 11:37 am
nice i do think they look good in white
Re: Here's the Ol' Gal
Posted: Sat Jan 18, 2014 11:46 am
Ride, wash, rinse, repeat.....
Ride may be repeated in multiples out of sequence.
Warning: Not dishwasher safe. Manual wash, air dry only.
Distance between mouth and ears may be permanently reduced by excessive adherence to above instructions.
edit: Nice photo
Ride may be repeated in multiples out of sequence.
Warning: Not dishwasher safe. Manual wash, air dry only.
Distance between mouth and ears may be permanently reduced by excessive adherence to above instructions.
edit: Nice photo
Re: Here's the Ol' Gal
Posted: Sat Jan 18, 2014 12:04 pm
^^ 
Ah yes...the "Whites" they do like to get pampered (could it be the color or lack there of?
)
Great shot of the Ol' Gal but I must know
What are the two screws (?) on the Tupperware under the bars? Did you put those there?
Ah yes...the "Whites" they do like to get pampered (could it be the color or lack there of?
)Great shot of the Ol' Gal but I must know
What are the two screws (?) on the Tupperware under the bars? Did you put those there?Re: Here's the Ol' Gal
Posted: Sat Jan 18, 2014 2:24 pm
Hi WhiteNoise, that's a warning sticker on the tupperware, I see what you mean about it looking like a couple of screws though.
If I had put a couple of screws there they would have been stainless like the ones I'm replacing the stock ones with
If I had put a couple of screws there they would have been stainless like the ones I'm replacing the stock ones with