The Honda PCX / Forza / ADV150 / SH Forums

Hello all. this is my fist post to this site and just a few days after i purchased my first ever Honda pcx. the thing is that when i bought the bike (at a pretty good price) it had a smashed up turn signal that needed be replaced because the last owner had a bit of a slip up while riding apparently. so, i was hoping that i could get some help on how to remove the little bugger. it is connected to a rubber bendable piece and it is hard to unscrew the bolt with the whole thing bending the way it does. here are a couple of pictures

http://i242.photobucket.com/albums/ff22 ... e9f814.jpg

http://i242.photobucket.com/albums/ff22 ... f09fb7.jpg

anyone have a diy or just a tip that would help me take this sucker off(turn signal, like the whole thing) and replace it with the new one?

i have looked everywhere in this site and surprisingly haven't found anything written up on it.

thanks in advance.

ps: the pictures are of the right side of the bike/turn signal..i will be replacing the left turn signal not the right one as is shown in the pictures.

Welcome, you have got to remove the cover "A" first, then it will be self explanatory, good luck!

well i figured that much...i sent this one in to get repaired at a local shop here in town..
upon further review when i was taking the panels off today i see that he had broken a few clips and the meter cover was cracked or that one piece that covers where the handle bar connects to the bike kinda. idk...your post didn't help much really.

Glad you found better answers here: http://hondapcx.org/viewtopic.php?f=3&t ... 100#p30910