Rear wheel
Posted: Mon Mar 12, 2012 9:28 am
Does anyone know the correct torque setting for the rear wheel hub nut.??
Cheere
Cheere
According to the Honda service manual:
118 N/m (12.0 kgf*m, 87 lbf*ft)
The Honda PCX / Forza / ADV150 / SH Forums
Your predominant source of information for the Honda PCX, Forza and SH! Now featuring an ADV150 subforum!
https://hondapcx.org/
Rear wheel
Page 1 of 1
Re: Rear wheel
Posted: Mon Mar 12, 2012 1:48 pm
Re: Rear wheel
Posted: Mon Mar 12, 2012 6:20 pm
You'll need a longish torque wrench for it too, and a 24mm socket.
Tighten the nut a good bit while the scooters on it's centre stand, then take it off the stand while standing to it's left, this will mean you can apply the rear brake and lean your weight over the bike while you torque the nut. I might be teaching my grandmother to suck eggs here.
Tighten the nut a good bit while the scooters on it's centre stand, then take it off the stand while standing to it's left, this will mean you can apply the rear brake and lean your weight over the bike while you torque the nut. I might be teaching my grandmother to suck eggs here.
Re: Rear wheel
Posted: Thu Mar 15, 2012 6:21 pm
Any advice is good advice thanks