The Honda PCX / Forza / ADV150 / SH Forums

Hi, Guys & Gals........

I have a question for you, is it possible to run with side lights and main beam together?

"I noticed by chance the other night while riding home, where i live! NO STREET LIGHTS. and when i went to put on the main beam i half pressed the switch and both main and running lights came on and lot more of the road was visible."

next time i get a chance i will take a photos, so you can see!!

Both sets of contacts were made live when half pressed, but it would seem you would need a re-wire job (or new switch) to do that - but fuse rating for the circuit will need checking, esp on a bulb higher wattage PCX.

That is why i put some extra lights on mine, like Maddiedog did. They have a separate switch, so i can choose when i want to turn them on...and they have their own inline fuse.

thanks guys, just ordered some led spots for the bike and installed some xenon effect bulbs from france link below

http://www.ledperf.co.uk/pack-of-2-bulb ... -5750.html

http://www.ledperf.co.uk/pack-of-2-halo ... p-901.html

I assume you mean the high beams and the low beams at the same time. I wonder if this would cause a heat issue with the bulb or the plastic housing?

I wondered that. What amp rating could the earth cable take on the bulb? Could it handle double the current?