Page 1 of 1
adapting a milk crate to my PCX
Posted: Fri Sep 04, 2015 12:11 pm
by chet
i want to install a milk crate on my PCX, is this the correct PN to mount a milk crate to. Honda Plate 08L70-KZY-910
did i miss any other adapters that will work better for a milk crate install.
Chet
Re: adapting a milk crate to my PCX
Posted: Fri Sep 04, 2015 10:29 pm
by WhiteNoise
Yes chet that is the correct rear rack part number for the 2013 and 2015. I'm not aware of any additional adaptors, and I'm pretty sure you won't need one (I have this exact rack on mine with a tailbag, no problem).
I bought it here:
http://www.amazon.com/Honda-08L70-KZY-9 ... +rear+rack
Re: adapting a milk crate to my PCX
Posted: Sat Sep 05, 2015 9:14 am
by chet
I might want to add to my above post, when i purchased the bike last week, it came with a grab bar and back rest,
http://www.ebay.com/itm/Honda-PCX125-15 ... 8f&vxp=mtr, this is the one on ebay my bike has, question is if I go with the Honda Plate 08L70-KZY-910, will it use the same holes to mount as the bar and rest i am going to take off.
Chet
Re: adapting a milk crate to my PCX
Posted: Sat Sep 05, 2015 10:35 am
by WhiteNoise
Oh, I've seen that backrest before here on the forum but that's all I know about it. It "appears" in the link you provided, that it does use the same mounting holes as the rear carrier rack. Why wouldn't it, makes sense right? hmm...
Take a look at what I dug up, some visuals may answer your questions. Hope so
http://www.hondapcx.org/viewtopic.php?f=3&t=947
http://powersports.honda.com/documentum ... ZY-910.pdf