Page 1 of 1
Variator "see if no about"
Posted: Fri Nov 27, 2015 2:38 pm
by troy
Hello! PCX scooter riders!
Has anyone used or know anything about Chameleon Factory variator set & drive face
on there PCX scooter???
Does anyone have any good photos of Raced out PCX SCOOTERS or links to sites of them?
Thanks
Re: Variator "see if no about"
Posted: Fri Nov 27, 2015 3:05 pm
by Oyabun
troy wrote:Hello! PCX scooter riders!
Has anyone used or know anything about Chameleon Factory variator set & drive face
on there PCX scooter???
Does anyone have any good photos of Raced out PCX SCOOTERS or links to sites of them?
Thanks
This guy would be my definition of running a raced out PCX.
Re: Variator "see if no about"
Posted: Fri Nov 27, 2015 5:03 pm
by Oyabun
Re: Variator "see if no about"
Posted: Fri Nov 27, 2015 8:34 pm
by BPT7594
Re: Variator "see if no about"
Posted: Fri Nov 27, 2015 11:17 pm
by homie
what is this......
Re: Variator "see if no about"
Posted: Sat Nov 28, 2015 12:46 am
by Oyabun
Yup. Thai PCX drag racers. They run on modified thin wheels to reduce dolling resistance to minimum.
Re: Variator "see if no about"
Posted: Sat Nov 28, 2015 1:21 am
by BPT7594
The Thais can drag race ANYTHING. If it has wheels and a motor, it's "drageable".
Re: Variator "see if no about"
Posted: Sat Dec 05, 2015 11:38 am
by waspmike
^
Re: Variator "see if no about"
Posted: Sat Dec 05, 2015 12:38 pm
by BPT7594
waspmike wrote:^
I sincerely think there's some Thais who would be more than willing to tune and drag race that thing
.
About the promised pics of my SH150 variator, very sorry I don't have the chance to take it, when I get new vario I'll take a comparison set for you, side by side with the stock SH150 vario. My mechanic knows what he's doing. I can reach 130 on my 150 with a Sonic piston and a 5.5mm lobe lift camshaft, tucking though.
Re: Variator "see if no about"
Posted: Sat Dec 05, 2015 10:07 pm
by waspmike
One of my customers just fitted a variator to his stock PCX150 and gave up his post fit testing at 120 and not yet on the limiter! He also said he was going slightly uphill!
That is a 117mm dia pulley so your SH150 one could be turned down to 120 but that then requires a Phd in belt lengths to allow the belt to go further out.