Page 1 of 1

When turn on ignition switch, not all PGM-FI indicator not o

Posted: Sat Nov 12, 2016 6:25 pm
by dylant66
Normally when turn on ignition switch, all light indicator should on few seconds, but today I only see the fuel gauge and speedometer on, the PGM-FI usually on then off, but not today, and when I started engine, nothing happen. I checked fuses, battery, engine switch, side stand, etc, nothing wrong, it just like no power get into starter and don't hear any sound. Do you have any idea? Thanks.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 7:11 pm
by Mel46
Sounds like your battery has too weak to do its job. See if you can get it jump started. If so, then time to replace the battery.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 8:30 pm
by dylant66
I replaced the battery last couple months, I also have have the battery charger, recharge full, but nothing happen. Like I said, starter not start at all.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 9:39 pm
by Jge64
Kill switch on?

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 9:53 pm
by relic
Kill switch on?
my first thought.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 10:23 pm
by dylant66
Yes, I did turn it on off to make sure, side stand up, and hold brakes when starting...

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sat Nov 12, 2016 10:42 pm
by relic
I see you posted that this all started when you took the case off to change your belt
kind of points to your side stand switch but you say that checks out?
I'm stumped.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sun Nov 13, 2016 6:08 am
by kramnala58
relic wrote:I see you posted that this all started when you took the case off to change your belt
kind of points to your side stand switch but you say that checks out?I'm stumped.
Dylant66 ... I am not sure where the post is that Relic is referring to, that you took the case off to change the belt, but that would be something I would check into.
I can't recall where, but there is a topic somewhere on the forums regarding disabling the side stand switch. I think it was earlier this year, but may have been longer ago than that. If you can find it, it may be of help.

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sun Nov 13, 2016 11:11 am
by WhiteNoise
Welcome to our forums :P Could you be remembering one of these threads?

http://www.hondapcx.org/viewtopic.php?f ... and+switch
Or
http://www.hondapcx.org/viewtopic.php?f ... and+switch
Or
http://www.hondapcx.org/viewtopic.php?f ... and+switch

I hope your resolve lies within one of them. "Search" is your friend,....Our friend ;)

Re: When turn on ignition switch, not all PGM-FI indicator n

Posted: Sun Nov 13, 2016 10:20 pm
by kramnala58
You are a rock star WN. If it can be found, you will typically find it.