Page 1 of 1
Oil in cvt housing
Posted: Mon Dec 10, 2018 8:06 am
by ScottBentley
Hi, I have had oil leaking from the drive belt housing on my 2015 pcx for some time now.Yesterday I changed the drive belt,when I removed the cvt cover it was lagged in engine oil. Once I had removed the pulley itself the oil appeared to be entering from around the pulley shaft itself. It is definitely engine oil as it is from the front shaft and I have checked the transmission oil. Does anyone have any ideas, is there an oil seal or gasket? Any help would be much appreciated..
Re: Oil in cvt housing
Posted: Mon Dec 10, 2018 10:06 am
by you you
Not good.
Just to be clear its coming from the crankshaft/variator end rather than the final drive/clutch end?
Re: Oil in cvt housing
Posted: Mon Dec 10, 2018 10:27 am
by springer1
Did you recently do an oil change or add oil? - overfilling will cause this.
Re: Oil in cvt housing
Posted: Mon Dec 10, 2018 2:27 pm
by fish
Re: Oil in cvt housing
Posted: Mon Dec 10, 2018 3:21 pm
by easyrider
Re: Oil in cvt housing
Posted: Tue Dec 11, 2018 4:46 am
by you you
easyrider wrote:
x2 .. or just use a pick
Or two self tappers and two pairs of pliers...