Page 1 of 1
problem about torque.... (pcx125 '13)
Posted: Wed May 08, 2019 11:50 am
by sjdkv234
hi guys. i'm korean pcx owner.
i have a question about pcx parts. i have a pcx125 (2013)
i replaced my pcx125(2013) parts to 15-17 pcx125 parts (drive-belt, weight-roller, drive-face, clutch-outer)
so, my pcx's torque became so weak now.. (0-60kph 9s.. before replacement, 5~6s)
is that different belt size '13 with '15-'17 ???
thx
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 09, 2019 6:14 am
by fish
I'd reinstall the old belt....and see what happens.
You might not have the correct new belt (all your new parts OEM HONDA ?, or not?
Fish
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 09, 2019 6:50 am
by gn2
You can check parts compatibility here:
https://www.bike-parts-honda.com/
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 09, 2019 7:37 am
by sjdkv234
fish wrote:I'd reinstall the old belt....and see what happens.
You might not have the correct new belt (all your new parts OEM HONDA ?, or not?
Fish
all parts are OEM HONDA stock all new pcx(15-17).
Do I reinstall only the belt??
thx for ur reply
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 09, 2019 10:50 pm
by sjdkv234
i have no old belt. all replaced by honda engineer..
i have no tools.. i think engineer discarded my old belt
Re: problem about torque.... (pcx125 '13)
Posted: Fri May 10, 2019 6:30 am
by fish
sjdkv234 wrote:i have no old belt. all replaced by honda engineer..
i have no tools.. i think engineer discarded my old belt
What did the mechanic say, when you explained your loss of power?
Fish
Re: problem about torque.... (pcx125 '13)
Posted: Fri May 10, 2019 8:28 am
by sjdkv234
fish wrote:sjdkv234 wrote:i have no old belt. all replaced by honda engineer..
i have no tools.. i think engineer discarded my old belt
What did the mechanic say, when you explained your loss of power?
Fish
i will visit honda tomorrow.
he said all '15-'17 parts which replaced are same with '13
but i cant believe it..
so, i need some information about these..
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 16, 2019 3:16 am
by accyuklad
You might have had heavier weights put in there's a chance 15 - 17 might be 18kg and you need 15kg
Or it's most likly belt as 2015 is different spec to 2013 this could be the cause
And I would make the garage replace it what dumb Mechanic uses incorrect stuff
Belt you need is 23100-KZR-601
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 16, 2019 3:33 am
by accyuklad
Also if the belt that's been put in is ribbed on outer belt then its defo incorrect one
he should have part number for belt
Also you can use 23100KWN901
Re: problem about torque.... (pcx125 '13)
Posted: Thu May 16, 2019 6:25 am
by accyuklad
I reckon the dealer that did the work probably couldn't be bothered ordering the stock and used what they had instore