The Honda PCX / Forza / ADV150 / SH Forums

Yesterday morning was the last run of the PCX before I trade it in for the Forza so I felt like sharing the last pic before it returns to stock.
Enjoy.

they are on there
the are just very low key
http://www.scooterworks.com/ncy-adjusta ... rYV5q13uHt

Maddie, as you can see her the grips have the throttle tube integrated
http://imageshack.us/scaled/landing/820/rizoma2.jpg

http://imageshack.us/scaled/landing/84/bolt1e.jpg

Raised the front by that much

Top was where the rear shock mounts to the frame and bottom was where it bolts to the transmission

I measured the distance before and after.

I didn't measure the front but I did raise it a little.

Sag is only 1/2 an inch
Since both front and rear springs where changed the difference was noticeable.
The only drawback is the fuel filler door pops open more now then before when I hit larger NYC potholes.

Shocks are E302's but it took me 3 tries to get the springs rates correct. Top speed was pushed to (I'm not starting this again) but it only added a little bit on top. But know it was massaged by a mechanic and it's both vario and clutch that was changed along with the springs and rollers and the be...

Just a little bit of my current setup http://imageshack.us/a/img263/2350/rizoma1.jpg Rizoma throttle tube and grip combo http://imageshack.us/a/img35/4214/shocks1.jpg YSS RE302 series shocks and springs(17-25 N/mm or 95-140 lb/inch) http://imageshack.us/a/img153/9896/screen1od.jpg Magical Racing dou...

Check your email Dave
Still can't PM you

Saša

Darn this thread.
We'll stitch it together eventually.

I just did the bottom 2 and not the turn signals.
Sadly when I finished those I gave up on doing the others.
Just too much work for the return.
Unless you really are adament on doing it yourself.
Good luck.

Before you start, realize that the back of the headlight has to be drilled out. It is not a question of just popping in holders and bulbs. At least in the US models. When i drilled out the lower holes a lot of the plastic shaving made there way into the inside of the headlight assembly and where a p...

Last year the wife and I vacationed in Rome.
Here are some random PCX stuff we picked through in 1 week.

Thanks Maddie, but look at the join date...mass exodus and all.

To me the metallic part looks damged from the fall.Try taking off the rubber bit. Stick a screwdriver into the metal tube and bend it away from the bolt (downward). It might help with getting a small 8mm socket in there. Take it slow bending it, if it breaks or cracks the replacement doesn't look li...