honda pcx power-full full led lo/hi

power-full · Post by **power-full** » Sun Nov 05, 2017 11:37 am

Here are the photos of the exchange of my lights, they were 36w / 36w x 8000lms / 8000lms x 6500k leds (each led lamp)
here is the video link

[youtube]https://youtu.be/9IwIfcTAcNc[/youtube]

power-full · Post by **power-full** » Sun Nov 05, 2017 11:39 am

https://youtu.be/9IwIfcTAcNc

here is the video link

Mel46 · Post by **Mel46** » Sun Nov 05, 2017 11:53 am

Did you have to split the light assembly to do the upgrade? I am considering working on mine over the winter. Changing the main bulbs shouldn't be difficult (I have some HS5 bulbs I want to install there), but the top and bottom light sockets are empty. Those are the ones I am considering doing something with.

power-full · Post by **power-full** » Sun Nov 05, 2017 12:03 pm

I did not do anything too much. only I applied the lamps "the ones I bought are h4) was to arrive and to assemble.
this as of origin is only in LEDs and has lots of light

Slowinitdown · Post by **Slowinitdown** » Sun Nov 05, 2017 12:51 pm

Nice upgrade. Makes the old bulb look like candlelight

power-full · Post by **power-full** » Sun Nov 05, 2017 1:08 pm

https://youtu.be/9IwIfcTAcNc

here is the video link

power-full · Post by **power-full** » Tue Aug 21, 2018 3:10 pm

hi hello .. this week I want to see if I'm the one next to mount my yuminashi kit on my pcx.
is the complete 164cc kit, I'll also fit the final gear kit, the AFR (injection driver). as well as the gasoline injector of greater debit "tuning of model honda cbr 150cc" and inertia power booster .
I will try to insert here the references of the material, my pcx is a 125cc 2010 model of the jf28 engine.

YUMINASHI FUEL-ADJUST CONTROLLER (5-PIN TO 5-PIN),38772-KWN-000A

44T FINAL GEAR SPROCKET SET, COMPLETE WITH SHAFT (PCX125 / SH125i)
23430-KWN-440

INERTIA POWER BOOSTER SET 15431-KWN-000

164CC LIGHT BORE FLAT DECK CYLINDER KIT (PCX125 V1) 12103-KWN-600XA

Honda Keihin injector assy (Tuning CBR 125150)16450-KPP-T01

homie · Post by **homie** » Tue Aug 21, 2018 3:21 pm

That's great!

power-full · Post by **power-full** » Tue Aug 21, 2018 3:27 pm

this is the material ... lol I have also mounted on the pcx malossi variator kit, contrast spring malossi yellow, belt gave up the malossi until see the polini is behaving well..lol
I also have the exhaust in stainless steel with the original tip .. I intend to change but you can not get everywhere €€€€€€€€€) lol