cutting height of acrylic windshield

[Jacito]

Does anyone have any insight about cutting the clear acrylic windshield? I have a Slipstreamer Scoot 50 from my last scooter, and I'd like to fit it to my PCX.

http://slipstreamer.com/scooter/scoot-50/

[Mel46]

That,... on a PCX?? Why?? I don't think it will look very nice on the pcx. There are a lot of manufacturers of windshields for the PCX, and those were meant for it...and they look nice on it. I can't imagine how that one will look on the pcx. I can't even imagine how your are going to attach it to your pcx. I assume you are going to attach it to the handlebar. That might mean pulling the original windshield off because the two may contact each other.

Well, good luck anyway.

[Jacito]

It attaches to the mirror mounts. My intention is to cut the upper section off and trim any area that may cause a contact problem.

[easyrider]

I used a portable jig saw with a fine blade. Very easily cuts through plexiglass I used tape on both sides and cut through the tape to avoid cracks . Then finish with sand paper to smooth finish the edge.