Belt, clutch & face set - 1st maintence after 4.5 years!

[tomtomclub2005]

... and send back that tool to the seller- ask for refund!

[iceman]

PS: I could try to scan my old face drive so you can make a template for drilling

That would be great - I was going to make something like the picture you posted, I believe there are 12 fins, but possibly not all usable due to different spacing?, I guess about 30mm from centre, but that's a guess. For the bolts, I was going to reverse feed them - bolt head + washer + nut then through and bolted on the other side, so the washer x (up to 12) will fit in the fins (whatever they are called) - ha! A template would be great - I tried searching for one for ages and could not find one with measurements.

[tomtomclub2005]

Hi Iceman,

Print this PDF out, make sure you select "actual scale" or 100%. I checked a print against the drive face and its accurate. It should be quite easy to drill a plank and use just two bolts...
Cheers,

Thomas

20181109092732.pdf

Drive face scan

(52.67 KiB) Downloaded 99 times

[iceman]

Thanks Thomas! Much appreciated!

[tomtomclub2005]

Wow that was fast!

Print the pdf not the image, image is not to scale...

[iceman]

Yep, saved the pdf, checked options and the printout has the two 'holes' 8cm apart I won't be able to get to this for a while as working most of the next 1-2 weeks inc weekends and nights, but hopefully if the weather holds I will be able to use this to make something. Thanks!