Best drive face option?

[logepoge1]

NCY Variator with NCY Drive Face 13g rollers i think... Bored stock out exhaust, pod air filter directly on the throttle body, down hill ninja tuck...

What kind of pod filter?

[dem0nk1d]

i'm using a pod filter from my pitbike engine off the Honda Passport. It's this one right here...

"40MM AIR FILTER"
http://www.amazon.com/40MM-FILTER-HONDA ... B007Q4AAQW

[logepoge1]

How'd you install it? I read something about the vacuum for the belt housing

[Mgalutia88]

No vacuum on our belt housing. Simple and straight forward.

[logepoge1]

i'm using a pod filter from my pitbike engine off the Honda Passport. It's this one right here...

"40MM AIR FILTER"
http://www.amazon.com/40MM-FILTER-HONDA ... B007Q4AAQW

Do you have picture of it installed

[logepoge1]

ImageUploadedByTapatalk1407461521.770896.jpg (276.42 KiB) Viewed 5078 times

This is my installation. I have a question though. Where does the hose below go?

ImageUploadedByTapatalk1407461507.954517.jpg (150.03 KiB) Viewed 5078 times

It was connected here:

ImageUploadedByTapatalk1407461484.388036.jpg (325.45 KiB) Viewed 5078 times

[logepoge1]

Okay the captions are kinda off because of tapatalk being weird but I'm sure you can figure it out

[Mgalutia88]

That would be the valve cover vacuum line. Install a breather on the end of the vacuum line or directly on the valve cover I needed. The further the better simply because of the oil coming into the airbox. In theory less or no oil is good but also vacuum on the crankcase is a good thing. We use to just Ben. The crankcase to atmosphere but the EPA doesn't seem to like that too much hence we have a catalyst in our exhausts.

[logepoge1]

Okay. I decided to leave the air box in same position but hair disconnected. So will that vacuum line be fine just kept connected to the air box?

[Mgalutia88]

i dont see why not. The airbox has a oil drain on it.

[logepoge1]

Wow the sound difference. Has a bit of lag at takeoff and no noticeable speed gains but maybe I need to reset computer?

[mikelx5]

if you have only done the filter no exhaust it can hurt your bottom so lighten your wieghts to get you higher in your rpm range faster

[logepoge1]

I have 10g sliders on

[dasshreddar]

You need to get an exhaust to feel any gains with that filter.
And its not a vacuum line, its just a breather/vent line.
I just have a L shaped hose(like the one in your hand pic) connected to the valve cover on mine, and of course NO airbox.

[logepoge1]

What exhaust is recommended?

[logepoge1]

I think I'm fine without performance increase. I like the sound. Sorry to hijack this thread

[mikelx5]

wow my bike must be slow lol im lightening my weights today

[Mgalutia88]

Suggested exhaust? Takegawa. Any of them.