Engine revving and wheel spin on idle.

Lemonbox36 · Post by **Lemonbox36** » Tue Aug 19, 2014 7:39 am

My pcx 125 is on, the engine is revving up to about 10mph on the speedometer and making a lot of noise. Problem is, I am not twisting or touching the accelerator at all. It only started this morning on my commute home from work, and didn't on the journey in 4 hours before. Any ideas?

Urbanfreestyle · Post by **Urbanfreestyle** » Tue Aug 19, 2014 7:45 am

Does the throttle have any play in it? generally speaking you should be able to twist the grip a little before you take up the tension on the throttle cable. If there is sufficient play i would recommend checking any vaccum pipes.

I'm not too sure though i'm just spitballing.

Lemonbox36 · Post by **Lemonbox36** » Tue Aug 19, 2014 7:56 am

No play on the throttle. Feels like its stuck on low power.

Urbanfreestyle · Post by **Urbanfreestyle** » Tue Aug 19, 2014 8:21 am

i'd suggest loosening off that cable as a starting point and see how it performs from there.

If it's only happened recently it could be a sticking choke but not too sure how they work on these bikes. I have yet to hear of cables shrinking! lol

chainsaw · Post by **chainsaw** » Tue Aug 19, 2014 7:32 pm

unhook the battery and let the ecu reset itself, then start checking for sticking cables.

WORFAB · Post by **WORFAB** » Sat Aug 23, 2014 10:02 am

no choke cause no carb

x2 for adjusting the throttle cable

Urbanfreestyle · Post by **Urbanfreestyle** » Sat Aug 23, 2014 11:45 am

Any luck?

The Honda PCX / Forza / ADV150 / SH Forums

Engine revving and wheel spin on idle.

Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.

Re: Engine revving and wheel spin on idle.