Seats: Does a 2015 seat fit a 2013 PCX 150?

[V65Mag]

I have a 2013 PCX 150, and even with the aftermarket seat the fellow who sold it to me had, along with the stock seat, it's bad. I was at the Honda dealer today, did not think to look or take a tape measure, but I sat on a 2015, and the seat is different, and wider where you sit, than the 2013.
I sat on it in the show room, and I understand sitting on a seat, in a show room, for 30 seconds, does no equal a ride, but in general the seat felt like it fit better. I contacted the overseas seat maker, but could not figure out how to order on their site....

[sendler2112]

do a hump removal on the stock seat and put it back on.

[Mel46]

The 2015 is so different that almost nothing is the same as previous models, including the seat. However, you can easily order a seat very much like the one on the 2015. Either go to powerbypcx.com or contact mpmotor by email. If you have a problem with how to order, just pm me and i will walk you through the process. If you have the Chrome browser it will translate the powerbypcx website for you. We have 2 of the 2013 pcx 150s. I ordered my wife's seat from powerbypcx.com and i ordered mine from mp motor. Both places have a large selection because both have them manufactured by the same company. On mine, i sent them my specific measurements and they made a custom, one of a kind, seat for me.

[Mel46]

http://www.hondapcx.org/viewtopic.php?f ... &start=140

This thread should help you find something that will fit.

[kiapolo1887]

do a hump removal on the stock seat and put it back on.

+1! I just did the hump removal on my stock seat and couldn't be happier (thanks to sendler2112 http://www.hondapcx.org/viewtopic.php?p=61269#p61269).

Here's pics of my humpectomy: https://imgur.com/a/5oeBs

[Mel46]

Since i purchased aftermarket seats from Thailand, i now have 2 original 2013 seats sitting in the basement, in case you screw up the dehumping and need another seat.

[Mr Bojangles]

Question for Mel46 or any one with same experience.
Just purchased a PCX125 and want to change the seat; hate the feel of the step. I like the ability to move my bum backwards to change my back angle.
I've looked at both websites, powerbypbx & MPmotor. I see you have purchased seats from both sites. Which do you think is the better quality?

[Scolds]

Thanks Mel46 for the links. I have just ordered one and hope to avoid any additional custom charges.