too much freeplay in throttle

McGee · Post by **McGee** » Wed Aug 26, 2015 11:34 pm

could someone advice me how to adjust too much freeplay in my throttle?
I would like to be kept as low as possible. Adjustment on the Handle or the Carburettor?
If someone could please point me in the right direction.
Advice reinforced with images from a Handbook would be deeply appreciated

dadragon · Post by **dadragon** » Thu Aug 27, 2015 1:03 am

What is to much?

waspmike · Post by **waspmike** » Fri Aug 28, 2015 11:07 pm

McGee,

Given your location pop down to Honda. Ask them to adjust it. Shouldn't cost more than 100 baht.

BTW there are two different versions. One has two cables the other only one.

Normal free play from conventional wisdom is about 3mm or 1/8 in old money.

McGee · Post by **McGee** » Sat Aug 29, 2015 9:48 pm

rite, thank you. will see the Workshop tomorrow as i need service anyway. b.t.w. i have two cables/

Mario · Post by **Mario** » Sun Aug 30, 2015 1:20 am

Throttle free play adjustment is a piece of cake diy job

This is from the SH300i service manual but technical the same,

waspmike · Post by **waspmike** » Sun Aug 30, 2015 2:20 am

Mario wrote:Throttle free play adjustment is a piece of cake diy job

But as there was some doubt and the OP lives in Thailand, where adjustment would cost less than $3, it only makes sense to go to the dealer.

The Honda PCX / Forza / ADV150 / SH Forums

too much freeplay in throttle

too much freeplay in throttle

Re: too much freeplay in throttle

Re: too much freeplay in throttle

Re: too much freeplay in throttle

Re: too much freeplay in throttle

Re: too much freeplay in throttle