GUIDE: Use remote answer back button to turn on my PCX

[nhatientri]

Now my PCX turn-on only i'm press answerback button on the remote.



i's use simple electric circuit, with OPTO and SCR, i've connect opto to Blue led ring of lock, and when press answer back button, it trigger opto and scr is closed.

[WhiteNoise]

Very interesting. Congratulations on finding an easier way to start your PCX (instead of fumbling with key in keyhole, using brake and start button). What about side stand? Up or down? You bypass it all?
Thanks for the video too
You are Sr. Member of forum.xda-developers dot com Viet Nam?

[you you]

I didn't understand a word of this.

Not specifically Whitenoise because that goes without saying, but rather the OP. Could you expand a bit for the dim like me please

[Mel46]

It looks like even putting the key in will not start it unless the remote is also activated. I don't know if the bike starts remotely though.

[iceman]

So the light ring triggers the 'opti-isolator' which then fires the SCR (open/close electronic switch (diode with an enable connection)) - it may help stop it being hot-wired but not before it's vandalised by those trying to hot-wire the bike, and good to always carry spare batteries for the remote.
A deeply buried GPS device is probably one of the better things to fit to expensive bikes - if the bike is stolen you can locate the bike over a web page from anywhere - at least it alerts you and the police to it's location. Worth the £60-200 they cost.

[WhiteNoise]

^^ ouuu....GPS, you might be onto to something.

What say you nhatientri? Are you still here?

[you you]

??????????????

[nhatientri]

I didn't understand a word of this.
Not specifically Whitenoise because that goes without saying, but rather the OP. Could you expand a bit for the dim like me please

sorry my English is bad,

i mean you need push the key in to keyhole, then press remote button to turn on the bike,

or you can press button on remote first,led ring on keyhole will be light up, then you have 1 minute to put key to keyhole to turn on bike. After 1 minute light off, you can't turn on

if you not press remote, you can't turn on your bike by key.

[nhatientri]

So the light ring triggers the 'opti-isolator' which then fires the SCR (open/close electronic switch (diode with an enable connection)) - it may help stop it being hot-wired but not before it's vandalised by those trying to hot-wire the bike, and good to always carry spare batteries for the remote.

A deeply buried GPS device is probably one of the better things to fit to expensive bikes - if the bike is stolen you can locate the bike over a web page from anywhere - at least it alerts you and the police to it's location. Worth the £60-200 they cost.

SCR work as a simple switch after keyhole, i tried it on my PCX few months and it work correctly without any problem,

Battery on the remote can live for few years,
You can use hidden switch in case remote is out of battery,

Agree, GPS is great sollution.

Very interesting. Congratulations on finding an easier way to start your PCX (instead of fumbling with key in keyhole, using brake and start button). What about side stand? Up or down? You bypass it all?
Thanks for the video too
You are Sr. Member of forum.xda-developers dot com Viet Nam?

I't just turn on power on bike, you still need brake and press start button,
i'm not sure what do you mean about "side stand" ?
yes, i'm from Vietnam.

[WhiteNoise]

Just saying, that if the side stand is down one can't start the scoot....correct?
That's all
Perhaps a bit of misunderstanding going on here? That is okay,....we just keep trying.
We'll Get It sooner or later
Any other scooter ideas, creations, mods to share?

[nhatientri]

yes, some ideas,

RPM, voltage, welcome screen
http://i.imgur.com/tATzr0E.jpg
http://i.imgur.com/wf8pERA.jpg


Add led ring to headlight
http://i.imgur.com/lRFevn9.jpg